![]() On the right side under Toolbox -> Target Device press the add button.Įnter the IP address of the ID40 192.168.251.30 Under Tools->EtherNet/IP Connection Settingsĭouble click the port you want to use with the ID40, in this case since its on the network – we use Port 2. Step 3 - NJ/NX Configuration EtherNet/IP Settings eds files to Sysmac Eds folder (depending on your Sysmac installation directory) default would be:Ĭ:\Program Files (x86)\OMRON\Sysmac Studio\IODeviceProfiles\EipConnection\Eds Once downloaded open and navigate through the compressed file Industrial Protocols -> EthernetIP -> Omron CJ2 -> eds. Scroll down until 2D Barcode Readers is visible and click on the red DRV box to download the drivers. In a browser visit the Microscan download center via this link. Network setup of the Microscan ID40 barcode scanner is now complete. Under the Start tab click on Assisted Setup.įor this setup we will read Any Code , 1 code at a time for a Continuous measure application. Type in the IP address of the scanner into a browser ( ). Test your connection settings by using Microscan WebLink. Under Parameters -> Ethernet the IP address should show 192.168.251.30 and EtherNet/IP should be enabled. Click Connect.Ĭlick YES when asked to receive reader settings. Or alternatively press Search to find the IP address of the scanner. Under Ethernet put the IP address of the scanner that was previously set (192.168.251.30). ![]() Run Microscan ESP and select the ID40 model hit OK then YES to connect to the scanner. In this example, the IP address is set to 192.168.251.30 which is on the same network as the NX102 Port 2. You should see the connected Microscan device as seen below.ĭouble click on the connected device to change the network settings. This will load up a web browser with address localhost:8992. Power up and connect the ID40 barcode scanner. Please refer to these Precautions and Terms and Conditions which relate to the information and program samples provided before proceeding Procedure Step1 - Microscan ID40 Barcode Scanner Configuration
0 Comments
Leave a Reply. |